NAVIGATING THE SOLO2™ LCD SCREEN
QUICK REFERENCE GUIDE
NOTE: This guide is meant to be used only as a brief, general
reference. For complete operating instructions, always refer
to the Operator’s Manual.
Turning Concentrator On/Off
NOTE: For this procedure, refer to FIGURE 1.1.
1. To turn the SOLO2 concentrator on, press and hold the
On/Off button until the three warning lights display
and the unit beeps.
2. To turn the SOLO2 concentrator off, press and hold the
On/Off button
.
NOTE: GREEN light will flash and you will hear the machine stop
running.
On/Off
Button
Mode/Return/
Highlight Button
Menu Screens Navigation
NOTE: For this procedure, refer to FIGURE 1.1.
1. After turning on unit, press and hold the Mode/Return/
Highlight Button
to scroll through the three SOLO2
concentrator menu screens.
NOTE: Screens will continue scrolling until the Mode/Return/
Highlight Button is released.
Normal Operating/Standby Screen
The Normal Operating/Standby screen shows either battery
strength gauge, fan operating, external power on and battery
charging icons, when applicable, or the current/last mode of
operation and output flow level selected.
SOLO2™ Quick Reference Guide
1
2. To save changes made on the LCD Adjust screen:
A. Press and hold the Mode/Return/Highlight Button
until a different screen appears.
Mode & Flow Adjust Screen
The Mode & Flow Adjust screen allows user to change the
current mode of operation and output flow (FIGURE 1.3).
NOTE: To adjust either the mode or flow, the Mode & Flow Adjust
screen must be displayed. If the battery level screen is displayed,
press the Mode/Return/Highlight
, Up/Increase
, or
Down/Decrease button for approximately two seconds (screen
should change to Mode & Flow Adjust).
NOTE: Any changes to the setting will not take effect until after the
screen flashes three times.
Up/Increase
Button
Mode/Return/
Down/Decrease
Highlight Button
Button
Changing Mode
NOTE: For this procedure, refer to FIGURE 1.3.
1. With the Mode & Flow screen displayed, press and hold
the Mode/Return/Highlight Button
for one second.
2. Wait until the Mode & Flow screen flashes three times.
SOLO2™ Quick Reference Guide
3
Adjusting Flow
NOTE: For this procedure, refer to FIGURE 1.3.
1. With the Mode & Flow screen displayed, press and hold
the Up/Increase Button
or Down/Decrease Button
until desired setting is achieved.
2. Wait until the Mode & Flow screen flashes three times.
Invacare Corporation
USA
© 2010 Invacare Corporation. All rights
reserved. Republication, duplication or
modification in whole or in part is
prohibited without prior written
permission from Invacare. Trademarks are
identified by ™ and ®. All trademarks are
owned by or licensed to Invacare
Corporation or its subsidiaries unless
otherwise noted.
One Invacare Way
Elyria, Ohio USA
44036-2125
800-333-6900
Technical Services
800-832-4707
Part No 1163220
Rev B - 01/10
|
Victory Refrigeration VDW 65 24 User Manual
Sony XR C9100 User Manual
Sony XR 1804 User Manual
Sony VCT 50AV User Manual
Sony HANDYCAM PMW EX1R User Manual
Sony Handycam HDR CX700VE User Manual
Sony DCR DVD703E User Manual
Sony CCD TR317 User Manual
Sony Camcorder DSR 250P User Manual
Samsung WB700 User Manual